Cisco 500-601 ACI Exam Practice Test Instant Access

Question 1

Which option describes the correct sequence to discover an ESX server in the fabric without a blade switch or multiple Layer 2 hops?

AThe leaf sends LLDP/CDP to the ESX, the ESX sends parsed UDP/CDP information to the vCenter, the AP1C receives LLDP/CDP information from the vCenter, and the APIC downloads the policy for VMs behind the ESX to the leaf node.

BThe APIC downloads the policy for VMs behind ESX to the leaf node, the leaf sends LLDP/CCP to the ESX, the ESX sends parsed LLDP/CDP information to the vCenter, and the APIC receives LLDP/CDP information from the vCenter.

CThe ESX sends parsed LLDP/CDP information to the vCenter, the leaf sends LLDP/CCP to the ESX, the APIC downloads the policy for VMs behind the ESX to the leaf node, and the APIC receives LLDP/CDP information from the vCenter.

DThe ARC receives LLDP/CDP information from the vCenter, the APIC downloads policy for VMs behind ESX to the leaf node, the leaf sends LLDP/CCP to the ESX, and the ESX sends parsed LLDP/CDP information to the vCenter.

Answer : B

Question 2

Which two actions occur when an EPG is being validated on a switch? (Choose two.)

AIDs assignment validation

BVLAN validation

Cpath validation

DBD, CTX configured validation

Answer : B, C

Question 3

Which two interface types can be used to configure interface profiles for the border leaf ports of a Layer 3 external routed network? (Choose two)

ALayer 3 subinterfaces

BLayer 2 ports with SPT-enaWed interfaces

CLayer 4 - Layer 7 route peering interfaces

DLayer 3 physical interfaces

ELayer 3 extended GRE tunnel interfaces

Answer : A, E

Question 4

Which command is used to successfully SSH into a Cisco ARC or switch CLI using a remote authentication server?

Aapic#rad_check//username@192.168.1.21

Bssh apic#rad_check\\username@192.168.1.21

Cssh apic#ad_chck//username@192.168.1.21

Dssh apic@rad_check\\username@192.168.1.21

Answer : C

Question 5

At which point during VMM integration do you need to create the vDS switch within vCenter?

Awhen starting up the VM

BNo need to create the vDS, the Cisco APIC controller does that automatically.

Cafter assigning the EPG to the VMM controller

Dbefore defining the VLAN pool that is assigned to the VMM controller

Answer : B

Question 6

Refer to the exhibit

Which option is a potential reason why you would see this output while provisioning a DVS?

AThe specified data center does not exist on the vCenter m question.

BThe Cisco APIC(s) cannot reach the vCenter host/vm.

CThe Service Content process has crashed.

DCisco Discovery Protocol is disabled on the vswitch policy tied to the corresponding AAEP.

Answer : A

Question 7

Which two statements are true regarding ARP request/response on an ACI Fabric? (Choose two.)

AARP requests come in on the elected/designated FD encapsulation VLAN under the BD.

BARP request can be captured using icpdump' on spine switches.

CARP traffic is handled by the broadcom ASIC it the two endpoints are in the same EPG and the same FD VLAN.

DARP requests are sent to CPU only if they are for the Bridge Domain SVI IP address

EELAM can be used to capture ARP request/response frames in the Leaf front panel Broadcom ASIC.

Answer : D, E

Cisco 500-601 Application Centric Infrastructure Support Representative ACI Exam Practice Test