AMPP Senior Internal Corrosion Technologist Exam Questions Instant Access

Question 1

Because a NACE Level 2 Inspector has been trained in specific destructive tests, it is up to the Inspector to decide If and when a destructive test is required.

ATrue

BFalse

Answer : B

Question 2

NACE/SSPC Water Jetting standards are directly equivalent to ISO Abrasive Blast Standards:

ATrue

BFalse

Answer : A

Question 3

The number of air turns in an enclosure can be affected by all of these EXCEPT

Atime of the year (winter/summer).

Btype of dehumidification equipment (refrigerant or desiccant).

Cmanufacturer of the equipment.

Dcoating type.

Answer : B

Question 4

When working with someone who Is very concerned about stability and maintaining adherence to the status-quo, the Inspector should try to:

AImplement Immediate changes to get them motivated

BGive them as much advance notice as possible about upcoming changes

CChallenge their value to the team and try to get them out of their comfort zone

DMake sure they are the center of attention in all site meetings

Answer : B

Question 5

Surface preparation of concrete is performed using:

AMethods that are exactly the same as steel

BMethods that are completely different to steel

CMethods that have been modified for concrete

DMethods that are the same as wood

Answer : C

Question 6

You are the NACE Coating Inspector on a tank lining project where desiccant dehumidification is being used. Since the first shift of abrasive Wasting your readings have indicated relative humidity below 40%; however on the second shift of coating application your readings are indicting 80%.

Your FIRST preferred course of action is to:

ACheck to see if the dehumidification equipment is operating correctly

BCall your supervisor

CAdvise the coating applicator supervisor of your readings

DDocument the readings at the end of the shift

Answer : C

Question 7

Inspectors perform tests on linings that they may not perform on exterior coatings because

Acoatings are more durable than linings.

Bcoatings are expected to degrade over time.

Clinings protect the contents and the container.

Dlinings are more durable than coatings.

Answer : C

AMPP Internal Corrosion for Pipelines - Level 2 Senior Internal Corrosion Technologist Exam Questions