Arista ACE-A1.2 Exam Questions Instant Access

Question 1

Which command will successfully configure Ethernet5 to be 40Gbps on an Arista 7150-52 switch?

AAn Arista 7150-52 dos not support 40Gbps

BSince Ethernet 5 is a 10Gbps port, 40Gbps is not possible.

CArista(config-if-Et5)#speed forced 40gfull

DArista(config-if-Et5)#speed 40gfull

Answer : C

Question 2

Which of the following statements is false?

AYou can run bash commands from CLI with the bash command.

BYou can run CLI commands from bash with the Cli command.

CYou can run CLI commands from bash with the FastCli command.

DYou can run CLI commands from CLI with the Cli command.

Answer : D

Question 3

Which of the following is not a DANZ feature?

ATap Aggregation

BAgile Ports

CAdvanced Mirroring

DMLAG

Answer : D

Question 4

What is the name of the Arista EOS feature that allows you to set triggers and perform actions on those triggers?

AEvent Manager

BEvent Monitor

CEvent Trigger

DEvent History

Answer : A

Question 5

What will the following command do?

show event-monitor arp | grep 10.100.100.6

AShow all the historical ARP entry changes on the remote Arista switch located at IP address 10.100.100.6

BShow all the event-monitors for a switch that has an ARP address matched to the IP address 10.100.100.6

CShow all historical ARP entry changes that contain the IP address 10.100.100.6

DThis is not a valid command

Answer : B

Question 6

Given the following output, what can you determine about Ethernet13?

AEthernet13 has a QSFP interface

BEthernet13 has a QSFP+interface

CEthernet13 is an Agile Port

DEthernet13 has a hardware error that is causing it to misreport its connection speed.

Answer : A

Question 7

Which command would you use to change the SSH Idle timeout after entering the 'management ssh' command?

Aidle-timeout <minutes>

Btimed <minutes>

Ctimeout <minutes>

Dssh-idle <minutes>

Answer : A

Arista Certified Engineering Associate ACE-A1.2 Exam Questions