Cisco 300-535 SPAUTO Exam Questions Instant Access

Question 1

Which command configures the remote peer when the Cisco IOS XR Traffic Controller is used?

Apeer-sync ipv4 192.168.0.3

Bstate ipv4 192.168.0.3

Cpeer ipv4 192.168.0.3

Dstate-sync ipv4 192.168.0.3

Answer : D

https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r6-2/segment-routing/ configuration/guide/b-segment-routing-cg-asr9000-62x/b-seg-routing-cg-asr9000-62x_chapter_01001.html

Question 2

Refer to the exhibit.

After this operation, what else is needed to change the hostname of the router to IOS-XR- SJC-19?

A<confirm>

B<close-session>

C<get-config>

D<commit>

Answer : D

Question 3

Refer to the exhibit.

Based on the YANG presented, what is the correct xpath to retrieve the router named ''ios- device'' under the ''CustomerA'' service name?

A/ncs:abc_service/CustomerA/ios-device

B/abc_service/CustomerA/''ios-device''

C/ncs:service/abc_service/''CustomerA''/ios-device

D/ncs:services/abc_service/CustomerA/ios-device

Answer : D

Question 4

Which Git command is needed to stage the file network-deploy.py to then commit the changes to the revision history?

Agit init network-deploy.py

Bgit add network-deploy.py

Cgit merge network-deploy.py

Dgit commit network-deploy.py

Answer : B

Question 5

The Netmiko BaseConnection class contains a method called ''send_config_set()''. Which two actions does this method perform on the device? (Choose two.)

AIt takes a filename parameter that executes commands contained in that file on the device.

BIt requires the user to explicitly send configure terminal and exit commands to the device to enter and exit configuration mode.

CIt automatically enters and exits configuration mode on the device.

DIt takes a Python iterable, such as a list of commands, and executes them in order on the device.

EIt saves the running configuration to the startup configuration after executing the configuration commands on the device.

Answer : C, D

Question 6

Refer to the exhibit.

When YDK is used to interact with Cisco routers, what is the purpose of passing intf_f into the crud_service.read() method?

AThe Interfaces() class acts as a NETCONF filter, which limits the data returned to that of the openconfig:interfaces YANG model.

BIt provides the data types of the openconfig:interfaces model to the router for dynamic configuration of the interfaces.

CIt locks the interfaces from modification by other active NETCONF sessions.

DIt passes default values into the crud_service, which reconfigures all interfaces to their default configurations.

Answer : D

Question 7

Refer to the exhibit.

Which HTTP authentication mechanism is being used?

Asimple

Bbasic

COAuth

Dtoken

Answer : B

Cisco Automating and Programming Cisco Service Provider Solutions 300-535 SPAUTO Exam Questions