Cisco 300-625 DCSAN Exam Questions Instant Access

Question 1

A storage network engineer is upgrading a Cisco MDS Director with dual supervisor modules. The install command is executed on the standby supervisor module but fails. Which action would have prevented this failure?

AAll FCoE interfaces configured on the MDS must be shut down before starting the upgrade.

BThe upgrade must be done on the active supervisor module only.

CCisco Fabric Services must be disabled before starting the upgrade.

DFabric Controller Service must be stopped before starting the upgrade.

Answer : B

Question 2

A storage administrator is configuring inter-VSAN routing on a fabric that contains duplicate domain IDs. Which feature must be configured to ensure continued operation?

Aauto topology

Btransit VSANs

CIVR NAT

Dvirtual domains

Answer : C

Question 3

Which port mode is used on an NPV device to connect to an NPIV core switch?

DNP

Answer : D

Question 4

Two stable fabrics have overlapping domains. After a switch from the first domain is joined to a switch from the second domain, both switches become isolated. What caused the problem?

AThe autoreconfigure option is disabled on both switches.

BThe autoreconfigure option is enabled on both switches.

CThe rcf-reject option is enabled on the interfaces.

DThe rcf-reject option is disabled on the interfaces.

Answer : A

Question 5

Refer to the exhibit.

A user who is logged in as an operator cannot update the zoneset. What is the cause of this issue?

AThe fabric is locked by admin on switch-2.

BHard zoning is enabled.

CMerge control is disabled.

DThe switch has a conflicting domain ID.

EThe fabric is locked by admin on another switch.

Answer : A

Question 6

A storage administrator wants to enable NPV in a Fibre Channel edge switch. Which configuration is supported in this mode?

ACisco Fabric Services distribution over Fibre Channel

BE Port connectivity to the core switch

Clocal switching of east-west traffic

DDynamic Port VSAN Membership

Answer : A

Question 7

A storage administrator is enabling DH-CHAP for the first time on a Fibre Channel fabric. Which condition must the administrator consider while configuring this feature?

ANTP must be configured on all devices or the configuration fails.

BThe MD5 hash must be used if TACACS+ or RADIUS authentication for FCSP is enabled.

CAll switches on the fabric must be configured for the same password.

DEnabling DH-CHAP protocol feature is unsupported on FCIP interfaces.

Answer : B

Cisco Implementing Cisco Storage Area Networking 300-625 DCSAN Exam Questions