Cisco 352-011 Exam Questions Instant Access

Question 1

Which two general SDN characteristics? (Choose two)

ASouthbound interfaces are interfaces used between the control plane and the date plane

BOpenFlow is considered one of the first Northbound APIs used by SDN controllers

CNorthbound interfaces are open interfaces used between the control plane and the data plane

DThe separation of the control plane from the data plane

EOVSDB is an application database management protocol

Answer : A, D

Question 2

Which option describes a design benefit of root guard?

AIt prevents switch loops caused by unidirectional point-to-point link condition on Rapid PVST+ and MST.

BIt prevents switch loops by detecting on one-way communications on the physical port.

CIt allows small, unmanaged switches to be plugged into ports of access switches without the risk of switch loops.

DIt makes the port go immediately into the forwarding state after being connected.

EIt prevents switched traffic from traversing suboptimal paths on the network.

FIt does not generate a spanning-tree topology change upon connecting and disconnecting a station on a port.

Answer : E

Question 3

When you design a network that uses IPsec, where can you reduce MTU to avoid network fragmentation?

Aon both ends of the TCP connection

Bon the side closest to the client

Con the side closest to the server

Din the WAN

Answer : A

Question 4

Which two foundational aspects of loT are still evolving and being worked on by the industry at large? (Choose two)

ARegulatory domains

BloT consortia

CStandards

DLow energy Bluetooth sensors

EWiFi protocols

Answer : A, D

Question 5

You are designing a new multisite data center network within the same city. You are using the newest routers that run OSPF and DWDM point-to-point interfaces for site-to-site connectivity. Your primary objective is to use the fastest possible method for interface failure detection. Which method achieves this objective?

AUDLD

BInterface event dampening

CLoS/AIS event faults

DFast-hello timers

Answer : C

Question 6

You are presented with requirements to design a development, testing and production environments. These environment should communicate with each other, yet they should be kept as separate failure domains. Which routing protocol should be configured on the links between the networks to support the design requirements?

AOSPF

BEIGRP

CIS-IS

DBGP

Answer : D

Question 7

You have been asked to design a high -density wireless network for a university campus. Which two principles would you apply in order to maximize the wireless network capacity? (Choose two.)

AImplement a four-channel design on 2.4 GHz to increase the number of available channels.

BMake use of the 5-GHz band to reduce the spectrum utilization on 2.4 GHz when dual-band clients are used.

CChoose a high minimum data rate to reduce the dory cycle.

DEnable 802.11n channel bonding both 2.4 GHz and 5 GHz to increase the aggregated cell throughput.

EIncrease the number of SSIDs to load-balance the client traffic.

Answer : C, E

Cisco Certified Design Expert Practical 352-011 Exam Questions