Cisco 500-451 ENUAE Exam Questions Instant Access

Question 1

Within Cisco ISE, which persona or node handles RADIUS requests and the Sponsor and Guest portals?

APolicy Administration Node

BGuest Service persona

CPolicy Service persona

DMonitoring persona

Answer : C

Question 2

Which feature is used on the Catalyst 6500 Series Switch for real-time traffic capture and decoding?

ALancope Lite

BPacket Monitor

CMini Protocol Analyzer

DInline Wireshark module

Answer : C

Question 3

What is ISE profiling?

Aa feature used to identify the endpoints based on network data obtained from a number of enabled probes

Ban ISE function used for applying security templates to endpoints when ISE is integrated with Cisco Prime Infrastructure

Ca dynamic policy feature that uses a number of enabled probes to apply the correct ACL to roaming wireless endpoints

Da form used for self-onboarding of wireless devices

Answer : A

Question 4

Which option describes the benefits of a secure BYOD architecture using SGT?

Acomplex network design and lower operational costs

Beliminates ACL explosion and offloads filtering to ASA for rich and scalable policy rule automation

Ccomplex network design and topology dependent segmentation using Security Group

DSegmentation using Security Group is topology dependent and offloads filtering to ASA for rich and scalable policy rule automation.

Answer : B

Question 5

When Cisco Catalyst 3850 Switches are implemented in a stack configuration, which command is used to verify the role of each switch in the stack, and what are the two roles supported?

Ashow switch stack role; active/standby

Bshow switch detail; active/standby

Cshow switch member; master/member

Dshow stack detail; master/member

Answer : B

Question 6

A customer wants to dynamically monitor the status of a critical route. Which feature should you recommend that the customer use?

AWireshark

BEmbedded Event Manager

CIP Service Level Agreement

DGeneric Online Diagnostics

Answer : C

Question 7

In the Converged Access solution, how does the controller display the access point name when there is no existing configuration for the AP?

AAP+IP address dotted decimal, for example, AP10.10.1.1

BAP+Ethernet MAC Address, for example, AP44d3:ca42.4337

CAP+IP address in hex, for example, AP0A.0A.01.01

DAP+Base Radio MAC Address, for example, AP18.33.9d.f1.40.50

Answer : B

Cisco Enterprise Networks Specialization 500-451 ENUAE Exam Questions