Cisco 500-920 DCITUC Exam Questions Instant Access

Question 1

What occurs that causes a Split Brain Issue with Fabric Interconnects?

AThe subordinate Fabric Interconnect detects heartbeat failure and declares itself primary

BManage configuration changes made with UCS Manager

CA quorum tie occurs that must be resolved by the SEEPROM

DBoth cluster links fail

Answer : A

Question 2

What is the next step after performing a UCS firmware upgrade, and downloading the latest drivers both for your RAID Controller and your Fibre Channel HBA?

Check the HCL

ANo Drivers are needed in a UCS environment

BApply the device driver update to the devices

CNo need to do anything Drivers are automatically installed for you

DTest device driver compatibility

Answer : D

Question 3

You are in the process of upgrading your UCS M3 Server to a newer UCS M4 Server. You associate the Service Profile to the new UCS Server, but it fails to boot You suspect of a failed boot hard drive. You check your RAID1 Boot LUN in UCS Manager, but see no error messages What could be causing the issue?

AThe newer Cisco UCS M4 Server is using flash drives, not hard drives

BThe newer Cisco UCS M4 Server is using disks of larger capacity than the previous UCS M3 Server

CA misconfiguration on the Service Profile Local Boot Policy

DA misconfiguration on the Service Profile Local Disk Policy

Answer : A

Question 4

In order to create an Inband Profile for Cisco Integrated Management Controller (IMC) connectivity, what do you need to perform first?

ACreate a Management IP Pool, a MAC Address Pool, and a VLAN Pool

BCreate an IPMI Policy

CCreate a Service Profile

DCreate different VLANs, with different VLAN IDs

ECreate a Management IP Pool, a VLAN. and a VLAN Group

Answer : C

Question 5

Which statement is true when using SPAN for Fibre Channel (FC) Traffic?

AFC port on Cisco UCS 6238UP can be used as a SPAN source

BWhen defining FC uplink port as the SPAN destination, system will automatically stop using that port as an uplink port

CAny port can be used as a SPAN destination port Even if it is defined as Eth uplink port it will be automatically converted to FC uplink port

DFor FC SPAN sessions we do not have to specifically enable the monitoring session

Answer : A

Question 6

Which two ports on a pair of Cisco Fabric Interconnects must be properly cabled for the pair to form a cluster? (Choose two )

AL1 > L1

BL1 > L2

CL2 > L2

DL2 > L1

Answer : A, C

Question 7

When troubleshooting UCS initialization issues that require Fabric Interconnect reboots, which Fabric Interconnect should be rebooted first?

AThe primary Fabric Interconnect

BBoth Fabric Interconnects must be rebooted simultaneously

CThe Cisco UCS Manager will determine with Fabric Interconnect to reboot

DThe subordinate Fabric Interconnect

Answer : A

Cisco Data Center Unified Computing Infrastructure Troubleshooting 500-920 DCITUC Exam Questions