Citrix 1Y0-231 Exam Questions Instant Access

Question 1

Scenario: A Citrix Administrator configures an access control list (ACL) to block traffic from the IP address 10.102.29.5:

add simpleacl rule1 DENY -srcIP 10.102.29.5

A week later, the administrator discovers that the ACL is no longer present on the Citrix ADC.

What could be the reason for this?

AThe administrator did NOT run the apply ACL command.

BThe simple ACLs remain active for only 600 seconds.

CThe simple ACLs remain active for only 60 seconds.

DThe Citrix ADC has been restarted without saving the configurations.

Answer : D

Question 2

Scenario: Users are attempting to logon through Citrix Gateway. They successfully pass the Endpoint Analysis (EPA) scan, but are NOT able to see the client choices at logon.

What can a Citrix Administrator disable to allow users to see the client choices at logon?

AQuarantine groups

BClient choices globally

CSplit tunneling

DnFactor authentication

Answer : B

https://docs.citrix.com/en-us/citrix-gateway/current-release/vpn-user-config/configure-client-choices-page.html

Question 3

A Citrix Administrator configured a load-balancing virtual server to utilize the least bandwidth load-balancing method. A service attached to this virtual server is brought into the effective state during production hours.

During the startup of a virtual server, which load-balancing method is used by default?

ARound-robin

BLeast connections

CLeast bandwidth

DCustom load

Answer : B

Question 4

While applying a new Citrix ADC device, a Citrix Administrator notices an issue with the time on the appliance.

Which two steps can the administrator perform to automatically adjust the time? (Choose two.)

AAdd an SNMP manager.

BAdd an SNMP trap.

CEnable NTP synchronization.

DAdd an NTP server.

EConfigure an NTP monitor.

Answer : C, D

https://docs.citrix.com/en-us/citrix-adc/current-release/system/basic-operations.html#how-to-synchronize-system-clock-with-servers-on-the-network

Question 5

Which three Citrix Gateway elements can be configured by the Citrix Gateway Wizard? (Choose three.)

AThe rewrite policy for HTTP to HTTPS redirect

BThe responder policy for HTTP to HTTPS redirect

CThe Citrix Gateway primary virtual server

DThe bind SSL server certificate for the Citrix Gateway virtual server

EThe primary and optional secondary authentications

Answer : C, D, E

Question 6

A Citrix Administrator wants to configure independent and isolated access on a single appliance to allow three different departments to manage and isolate their own applications.

What can the administrator configure to isolate department-level administration?

ADedicated routes in the admin partitions for each department

BAdmin partitions that use dedicated VLANs

CPolicy-based routes for each department in the nsroot partition

DA VIP in each partition, and bind a VLAN for the department

Answer : B

Question 7

Scenario: A Citrix Administrator configured a new router that requires some incoming and outgoing traffic to take different paths through it. The administrator notices that this is failing and runs a network trace. After a short monitoring period, the administrator notices that the packets are still NOT getting to the new router from the Citrix ADC.

Which mode should the administrator disable on the Citrix ADC to facilitate the successful routing of the packets?

ALayer3

BUSNIP

CMAC-based forwarding (MBF)

DUSIP

Answer : C

Citrix Deploy and Manage Citrix ADC 13 with Citrix Gateway 1Y0-231 Exam Questions