Dell EMC DEA-5TT2 Exam Questions Instant Access

Question 1

What are the Protocol Data Units (PDUs) called at the Transport layer?

AData Payload

BFrame

CSegment

DPackets

Answer : C

Question 2

Which Layer 1 device can be used to enlarge the area covered by a single LAN segment?

ARouter

BRepeater

CSwitch

DNIC

Answer : B

Question 3

Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?

AN1500 Series switch and N2000 Series switch

BN1700 Series switch and N1500 Series switch

CN1700 Series switch and N3500 Series switch

DN3500 Series switch and N2000 Series switch

Answer : A

Question 4

What are Network Address Translation (NAT) inside global addresses?

AAddresses used by NAT router when sending frames to devices on the local network

BPublic IP addresses used by the local network to communicate with the Internet

CPrivate IP addresses used by the local network

DPubic addresses used by other networks outside of the local network

Answer : B

Question 5

Which option is used to configure Network Address Translation (NAT) to provide one-to-one mapping between local and global addresses?

AOutside source static

BOverload

CInside source static

DPAT

Answer : C

Question 6

A network administrator is troubleshooting an OSPF routing issue. There are two paths to a destination network from one switch. In addition, one path is comprised of four 1 Gb links. The other path is comprised of two 1 Gb and two 100 Mb links. The administrator ran several trace routes and notices that the packets are swapping back and forth between the two paths.

Which corrective action must be taken on the switch infrastructure to correct this issue?

AManually specify the OSPF Router ID on each switch within the path.

BBreak the paths into multiple OSPF areas.

CChange the reference speed used by OSPF in cost calculations on all switches within the path.

DSwitch all routing protocols to RIPv2.

Answer : C

Question 7

You recently joined a company as a junior-level network administrator. You have been tasked with designing the IPv4 scheme for five networks that will be used for training classrooms. These networks need to support no more than 28 devices each. Due to the existing network design, the senior-level network administrator has asked you to work on network 192.168.40.0/24.

If all networks must be made to logically start with the lowest numbered network and end with the largest numbered network, what is the network ID for the third network?

A192.168.40.32/27

B192.168.40.64/27

C192.168.40.96/27

D192.168.40.128/27

Answer : B

Dell EMC Associate - Networking DEA-5TT2 Exam Questions