Dell EMC DEE-1721 Exam Practice Test Instant Access

Question 1

An SC7020 is being deployed that will connect to servers using FC. What is one way in which FC fault domains are created when using the Dell Storage Manager Storage Configuration wizard?

AFault domains are manually created when the zoning configuration is specified in the wizard and the cables are plugged in.

BFault domains are automatically create when cables are plugged in and a Support Assist is completed

CSystem automatically create fault domains if FC cables are plugged in at the time the controllers join together

DSystem automatically create fault domains if cables are plugged in and the zones are pre-defined

Answer : A

Question 2

A storage administrator is preparing for severe weather conditions that may impact the primary data center location. As a result, the administrator decided to switch the production workload moved to the secondary data center, the administrator begins receiving telephone calls reporting significant poor performance.

What is most likely causing the performance issue?

AReplication restore point were not verified before switching the production workload secondary data center

BLive Volume replication is no longer active after failing over the production workload to the secondary data center

CVolume were replicated to the lowest tier of storage in the secondary data center

DHigh Priority checkbox was not marked when switching the production workload to the secondary data center

Answer : D

Question 3

You need to upgrade an existing dual controller SC030 to a dual controller SC8000storage array. While preparing to start the physical upgrade, you need to documents the existing port configuration. Which steps are required to accurately document the existing poet configuration?

AOption A

BOption B

COption C

DOption D

Answer : B

Question 4

Exhibit:

Based on the exhibit, Volume X is configured as a 300 GB volume and the data is split across two different tiers with multiple RAID types. What is the total amount of space lost to RAID overhead for Volume X?

A3.09 GB

B6.11 GB

C7.01 GB

D10.04 GB

Answer : D

Question 5

A storage administrator has an 8 TB database. Half of the data is hot and frequently accessed. The other half of the data is older with infrequently used cold data. The administrator purchased 12, 800 GB SLC SSDs and placed them in a new disk folder called ''Database''.

The administrator then created volumes for this database in the Database disk folder using the recommended storage profile. After the database had been running for one month, the Statistics tab for the database volumes showed 100% of the space is on Tier 1. However, the administrator expected that half of the data would be on Tier 1 and the rest would be moved to lower tiers.

What are the reasons for this issue?

AVolumes were created in the Database disk folder
Data Progression cannot move the cold data to the lower tier disks

BData Progression does not run on database volumes
Database vendors have specific requirements for laying out their data across tiers

CSufficient space is available on Tier 1 for the entire 8 TB database
Event cold data will remain on Tier 1 until it becomes full

DRecommended storage profile will only use SSD tiers if any are available
Cold data cannot move to the lower tier disks

Answer : A

Question 6

When configure ports in the Setup wizard, which purposes can be set on a port in Virtual Port Mode?

AFront-end, Front-end Reserved, and Front-end Primary

BBack-end, Unknown, and Front-end Primary

CFront-end, Front-end Reserved, and Back-end

DBack-end, Unknown, and Front-end

Answer : D

Question 7

During an upgrade, what should be selected in the I/O Card Change wizard if the slot/port combination is no longer used?

AI/O Card Changed

BConfigure I/O Card

CI/O Card Has Been Removed

DConfigure New Zone

Answer : B

Dell EMC DEE-1721 SC Series Expert Exam Practice Test