Dell Specialist – Implementation Engineer, Campus Networking Version 1.0 DES-5121 Exam Questions

A network administrator is setting up a Class 5 powered device in their network.

Which Dell EMC N-Serves switch model(s) will support this device?

An administrator just finished configuring a Dell EMC N-Series switch. After rebooting the switch, the administrator notices that all the configuration settings just entered are gone.

Which command did the administrator fail to enter?

Switch-1(config)# interface tengigabitethernet 1/0/1

Switch-1(config)# switchport mode access

Switch-1(config)# switchport trunk allowed vlan 10, 20

Switch-1(config)#

Switch-1(config)# interface tengigabitethernet 1/0/3

Switch-1(config)# switchport mode access

Switch-1(config)# switchport access vlan 10

Switch-2(config)# interface tengigabitethernet 1/0/2

Switch-2(config)# switchport mode trunk

Switch-2(config)# switchport trunk allowed vlan 10, 20

Switch-2(config)#

Switch-2(config)# interface tengigabitethernet 1/0/6

Switch-2(config)# switchport mode access

Switch-2(config)# switchport access vlan 20

A network administrator is troubleshooting why Host 1 cannot communicate with Host 2.

Based on the switch output shown in the exhibit, what is the reason for the communication issue?

Based on the exhibit,

which configuration on interface Gi1/0/18 will allow the DHCP request to reach the DHCP server for the specified VLAN?

Which default security level can be assigned to limit access of a specific user to a Dell EMC N-Series switch?

You need to configure OSPF on a DNOS 6 switch and have entered the following:

Switch-1(config)# ip routing

Switch-1(config)# interface vlan 20

Switch-1(config-if-vlan20)# ip address 10.1.20.1 255.255.255.0

Switch-1(config)# router ospf

Switch-1(config-router)# router-id 10.1.1.1

Based on the information referenced above, what is missing from the configuration?

Which AAA method is only used for 802.1x and never returns an error?