HP HPE0-S54 Exam Questions Instant Access

Question 1

A customer is using a DL380 Gen10. They attempt to boot an installation media ISO with iLO Virtual Media, and the system fails to access the ISO. What are the most likely causes of this issue? (Select two.)

AHPSSA drives are configured for RAID 1 and not RAID 5

BLegacy Boot is not enabled and the media is not UEFI compatible

CSecure Boot has derived access to the ISO

DThe ISO operating system is not supported by HPE

EUEFI is not configured for iSCSI initiator support

Answer : C, D

Question 2

One of the DL380 Gen10 servers in your infrastructure has failed to boot after a 3rd party PCle NIC was installed.

What is the most likely cause of this issue?

AHPE does not allow 3rd party PCle cards.

BThe latest Support pack for ProLiant must be used before accessing any additional 3rd party products in the server.

CThe manufacturer did not digitally sign the correct firmware and HPE Secure Boot halted the process.

DThe iLO interface did not have a correct IP address provided from DHCP.

Answer : C

Question 3

A customer purchased HPE ProLiant Gen10 servers. The customer is transitioning from a physical to a virtual environment.

Which feature should be enabled to ensure that they get the optimal performance from their new servers?

AUEFI optimized boot

BIntegration with an HPE OneView for VMware vCenter

CPerformance optimization using the workload profiles

DOneView OS Build Plan

Answer : C

Question 4

Your customer has completed a successful Synergy Proof of Concept (PoC) consisting of a single frame with dual composers and dual Virtual Connect SE 40Gb F8 modules.

The customer wants to:

add a second frame before they move into production

have unified management

have a separate logical enclosure for each frame

What are the basic steps to add the second frame? (Choose three.)

AMove the standby composer to the second frame.

BDisconnect the existing management ring, and then cable the FLM (frame link module) in the first frame to the FLMs in the second frame.

CInstall a satellite module in the first frame.

DMove the bottom VC module from the first frame to the second.

EMove one of the uplinks from the FLM in the first frame to a FLM in the second.

Answer : A, B, E

Question 5

While installing a three frame Synergy solution, only two of the frames are identified during the discovery process.

What should you do to get resolution?

ARemove and re-insert the standby Composer

BIssue a refresh command to the enclosure

COpen the front panel of the Composer, and read the error message

DValidate Frame Link Module topology

Answer : D

Question 6

A customer has a ProLiant DL based Gen10 server solution hosting an I/O intensive 2TB database. The customer needs to dramatically increase the performance of their existing system.

Which solution will provide the maximum performance possible for their application?

AInstall HPE Scalable Persistent Memory

BMove the OS to an M.2 SSD drive

CUpgrade the current processor to a Xeon-Platinum

DInstall DD4 Smart Memory

Answer : A

Question 7

A customer asks for a network technology that will maximize throughput and minimize latency and CPU utilization across servers using SMB Direct and 10Gb Ethernet.

Which technology should you propose?

ATCP/IP Offload Engine

BRDMA

Cvirtual extensible LAN (VXLAN)

DInfiniBand

Answer : B

HP Designing HPE Server Solutions HPE0-S54 Exam Questions