HP HPE2-K45 Exam Practice Test Instant Access

Question 1

What happens if an HPE mniStack Virtual Controller (VC) fails in a multi-node HPE SimpliVrty cluster?

AAll VMs on the node restart in a node where the replica resides.

BHPE SimpliVity Intelligent Workload ptimizer restores the VC from backups.

CThe IP address of the VC fails over to another HPE SimpliVity node.

DAll VMs on the node go on standby mode to avoid data loss.

Answer : A

Question 2

A customer wants to provide access to the HPE SimpliVity datastores for compute nodes running CPU-intensive virtual machines. What should you tell the customer?

AIt is supported to connect up to 5 compute nodes per SimpliVity node.

BAdditional license is required to connect ESXi nodes to SimpliVity datastores.

CConnecting ESXi compute nodes is possible only when VMFS datastores are configured at SimpliVity Federation level

DCompute nodes must reside in the same cluster as HPE SimpliVity nodes.

Answer : B

Question 3

A customer wants to provide access to the HPE SimpliVity datastores for compute nodes running CPU-intensive virtual machines. What should you tell the customer?

AIt is supported to connect up to 5 compute nodes per SimpliVity node.

BAdditional license is required to connect ESXi nodes to SimpliVity datastores.

CConnecting ESXi compute nodes is possible only when VMFS datastores are configured at SimpliVity Federation level

DCompute nodes must reside in the same cluster as HPE SimpliVity nodes.

Answer : D

Question 4

Refer to exhibit:

You are using Restore Virtual Machine for a given virtual machine. Which result is achieved by thrs operation?

AVirtual machine boot partition mapped as IS image to another VM

BNew snapshot added to existing virtual machine

CNew linked-clone created

DNew virtual machine created out of this backup

Answer : C

Question 5

You try to delete an existing datastore, but the operation fails. What is a likely cause of the failure?

AThe datastore is marked as read-only.

BThe FC connection between the host and array has failed.

CThe management network for a host is disconnected.

DThis datastore is not added to your scope.

Answer : A

Question 6

A customer plans to use HPE SimpliVity RapidDR, but is concerned about vCenter Server license cost. In which deployment scenario is only a single vCenter Server required?

Awhen less than 600 VMs is covered with a single recovery plan

Bwhen Enhanced Linked Mode is enabled for vCenter

Cwhen Intelligent Workload ptimizer is disabled

Dwhen federation is managed centrally

Answer : D

Question 7

At which level you can apply a backup policy?

Acluster

Bdatacenter

CvCenter Server

Ddatastore