HP HPE6-A41 Exam Practice Test Instant Access

Question 1

Refer to the exhibit.

A network administrator connects several new Aruba Instant APs (at factory defaults), as shown in the exhibit.

After waiting several minutes for the cluster to form, the administrator is ready to provision the cluster. The administrator wants to be redirected to the Instant UI without the need to know the correct IP address.

How should the administrator connect the management station to enable access to the virtual controller (VC)?

Ato a switch port in the same VLAN

Bdirectly to one instant AP's second Ethernet port

Cto the Instant SSID

Ddirectly to one Instant AP's Basic Service Set (BSS)

Answer : D

Question 2

Which standard for wireless connectivity supports both 2.4GHz and 5GHz?

A802.11a

B802.11ac

C802.11g

D802.11n

Answer : D

Question 3

A network administrator wants to form a cluster with several Aruba Instant APs (IAPs). What must the

administrator verify?

Athat all APs are the same model

Bthat all APs are operating on the same radio channel

Cthat all APs are connected in the same subnet

Dthat all APs are pre-configured with WLANs with the same SSID

Answer : D

Question 4

A company needs a switch that supports 10GbE and 40GbE for its mid-sized campus. The company prefers stackable, or fixed port, switches over modular switches. Which ArubaOS switch series best meet these needs?

AAruba 2530

BAruba 2930F

CAruba 3810

DAruba 5400R

Answer : B

Question 5

Member 1 is the commander of a Virtual Switching Framework (VSF) fabric. A power disruption causes

member1 to go down. What happens when power is restored and member 1 boots?

AMember 1 fails to rejoin the VSF fabric, and the error disrupts member 2.

BMember 1 rejoins the VSF fabric and becomes the commander.

CMember 1 rejoins the VSF fabric, and member 2 continues to act as commander.

DMember 1 fails to rejoin the VSF fabric, and member 2 continues to act as commander.

Answer : B

Question 6

Refer to the exhibit.

This switch currently assigns all VLANs to MSTP instance 0 or the Internal Spanning Tree (IST).

Which statement correctly describes interface 21?

AThe interface is down at Layer 2; it is not available for sending or receiving any traffic.

BThe interface does not forward or accept data traffic, but it is ready to start forwarding if interface 19 fails.

CThe interface is an edge port but has received Bridge Protocol Data Units (BPDUs), so it is disabled.

DThe interface does not support spanning tree: it is possible that it will introduce a loop in the network.

Answer : B

Question 7

Why would a network administrator use strict provisioning to configure the standby member in a Virtual Switching Framework (VSF) fabric?

AThe network administrator wants to control which device can join the VSF fabric.

BThe network administrator needs to configure the correct domain ID on the standby member before this member joins the VSF fabric.

CThe network administrator wants to ensure the standby member is configured with the same settings as the commander.

DThe network administrator does not know the MAC address of the standby member.

Answer : A

HPE6-A41 Applying Aruba Switching Fundamentals for Mobility Exam Practice Test