Huawei H12-261 HCIE-Routing&Switching Exam Questions Instant Access

Question 1

As shown in the configuration management, R1 OSPF R1, () staff configured but can not learn the routing of other routers, then the possible reason is.

[R1]ospf

[Rl-ospf-1]area 2

[R1-ospf-1-area-0.0.0.2]network 10.0.13.1 0.0.0.0

AThe area configured by this router is different from the area ID ID of its home router.

BThis router is not configured with the number OSPF

CThe router's announcement network address does not match the interface mask.

DThis router is not configured with functional authentication, but the router is configured with function neighbor authentication.

Answer : A, D

Question 2

Huawei exchanged two sets of SWA.SWB 7 , SW connected through the root Ethernet and configured the static channel aggregation chain to change the port corresponding to

Ethernet1/0/3. Ethernet1/0/3. Ethernet1/0/4. Ethernet1/0/5. Ethernet1/0/6. Ethernet1/0/7, configuration mode.

The order is configured in turn if the exchange is changed to SWA.SWB 6 Each aggregation only supports group ports.

AWhen the configuration of each port is consistent, port, Ethernet1/0/7 Unselected

BWhen the configuration of each port is consistent, port, Ethernet1/0/6 Unselected

CIn the case of consistent port configuration, random port aggregation in each port, SWA 7 Unselected selected as group port

DIn the case of consistent port configuration, port, Ethernet1/0/1 Unselected

Answer : A

Question 3

Which of the following statements regarding LACP are true?

AYou can run the following commands to enable loop balancing based on source IP address for an Eth-Trunk interface eth truck1
Load balance are dst-ip

BYou can run the following command to prevent flapping due to physical link faulth on an Eth_Trunk.
Interface eth trunk 1
Loop preemp enable
Loop preemp delay delay time

CYou can run the following command to add member interface to an Eth Trunk:
Interface Gigabitethernet0/0/1
Shutdown
Interface ethptruck 1
Trunkport Gigabitethernet0/0/1
Interface Gigabite thernet0/0/1
Undo shutdown

DYou can run the following commands to delete member interface from an eth-trunk interface GigabitEthernet0/0/1
Shutdown
Interface GigabitEthernet0/0/1
Unod eth-trunk 1
Interface GigabiteEthernet 0/0/1
Undo shutdown

Answer : B, D

Question 4

ISIS DIS DIS ?( ) will access the election in the broadcast multiplex network. The following is correct.

AISIS DIS MAC is better than the first-ranked election. If it is consistent, it is better than the priority.

BDIS CSNP is sent periodically to send messages to keep the data synchronization certificate

CAccessing the network in a broadcast multiplex network, sending DIS Hello PDUs at a rate of three times

DDIS DIS LSP support occupies the function, the new one occupies the success, does not need to flood any text

Answer : A, B, C

Question 5

The following is about the address of the method VPNv4, ? said to describe the error

ABy default, the PE VPNv4 vpn-target does not filter the route.

BVPNv4 12, 8 RD (Route Distinguisher) 4 The IPv4 address has a total of bytes including the route identifier of the word and the section address prefix of the word.

CLocally, the routing information from the PE site VPNv4 PE, Target, which is directly related to itself, is sent to the previous routing.
The Build attribute of BGP is distributed with the routing extension.

DIn the reachable and unreachable BGP VPNv4, the RD carries the attribute when it routes.

Answer : A

Question 6

Both IS-IS CSNPs and OSPF DD packets describe the brief information about link state databases in MA network.

Which of the following statements regarding the two types of packets is true?

AAfter CSNPs and DD packets are received by the peer router, the peer router needs to send an acknowledgement message; otherwise, the packets need to be retransmitted.

BOnce the neighbor relationship is established, CSNPs and DD packets are not sent.

CThe master/slave relationship in OSPF DD packet exchange is not bound to DR/BDR; and CSNPs are generated only by the DIS.

DAfter CSNPs and DD packets are received by the peer router, the peer router does not need to send an acknowledgment message.

Answer : D

Question 7

As shown in the figure below, an enterprise wants to implement secure access between the headquarters and branches through MPLS VPN. VPN traffic of branches must be forwarded through the headquarters for traffic monitoring. Which of the following statements regarding this solution is false?

AWhen the Hub-CE and Hub-PE use EBGP to transmit routing Information, the Hub-PE must be able to accept routes with the AS number repeated once so that routes advertised by the Hub-CE can be received.

BOSPF can be used to exchange routing information between Hub CEs and Hub-PEs as well as between Spoke-PEs and Spoke-CEs.

CBGP can be used to exchange VPN routing information between CEs and PEs.

DThe MP-IBGP peer relationship can be established between Spoke-PEs to exchange VPN routing information

Answer : A

Huawei HCIE-Routing & Switching (Written) V3.0 H12-261 HCIE-Routing&Switching Exam Questions