Huawei H19-424_V1.0 Exam Practice Test Instant Access

Question 1

The statement about campus NCE user access authentication is incorrect

APortal authentication, MAC address authentication, and 802.1X authentication are supported

BPortal page customization is not supported, but it supports docking with third-party Portal servers

CThe authentication data is transmitted using HTTP2.0 and Radius protocols, and the configuration data is transmitted using the Netconf protocol

DSupport docking with social media such as Weixin

Answer : B

Question 2

In the multi-campus interconnection LAN-WAN convergence scenario, refer to the following topology [Campus topology-8 [The description of the design and deployment of the dual-gateway Interlink solution is incorrect ()

ASynchronize information between dual-gateway devices through the interlink control sub-interface, such as the synchronization and backup of application recognition results, overlay connection information, and connection quality information. Interlink serves as a dual-gateway device interconnection interface that forwards inter-device (VPN) traffic through sub-interfaces.

BInterlink serves as a dual-gateway device interconnection interface, providing forwarding of inter-device service (VPN) traffic through sub-interfaces.

CInterlink can be interconnected with a direct link, and when the site service traffic is large and the CPE port resources are sufficient, it is recommended that Interlink use an Eth-trunk link. Interlink cannot borrow Layer 2 service interfaces on the CPELAN side.

DInterlink cannot borrow the Layer 2 service interface on the CPE LAN side

Answer : D

Question 3

The description of the dual-border and WAC interconnection design of the campus distributed gateway is incorrect ()

AIn the overlay interconnection solution, it is recommended to run the VRRP VRRP virtual address between the two borders as the gateway for wireless users

BDuring wireless centralized forwarding, the WAC and the border need to manage IP communication and service VLAN communication, that is, the underlay and overlay need to be connected.

CDuring wireless local forwarding, only the management IP address needs to be communicated between the WAC and the border, that is, the underlay is connected.

DSupported networking: WAC dual-node hot standby (VRRP dual-node hot standby or dual-link hot standby), and dual-border port sub-networking, recommended dual-node VRRP hot standby: In multi-campus interconnection LAN-WAN convergence scenarios, refer to the following topology

Answer : A

Question 4

In the CloudCapmus solution, NETCONF/YANG does not support the management of Huawei devices

ACloudEngine S series switches

BCE series switches in data centers

CWLAN AP

DAR series routers

EUSG series firewalls

Answer : B

Question 5

If the device suddenly goes offline during the configuration delivery process, what error message may be displayed in the configuration result?

AConfiguration service exception. Contact maintenance engineerenetconf communication failed

BService process faied

CThe service is abormal

DUnrecongnizeinformation

Answer : A

Question 6

In the southbound protocol of the controller, the () protocol collects topology information in real time?

APCEP

BBGP-LS

CNetconf

DTelemetry

Answer : B

Question 7

The opcode parameter description in SRv6 basic data plan is incorrect ()

AThe static Opcode needs to be configured within the static segment range to prevent conflicts with the Opcode dynamically allocated by the IGP protocol. The static segment length range is determined by the static static-length parameter of the locator command.

Bend-op, and end-m need to be statically configured

Cend, end-x, end-dt4, end-dt6, and end-dx2 can be dynamically assigned or statically configured

DThe SRv6SID format is Locator:Function:Args, where the Args field is also called Opcode

Answer : D

Huawei H19-424_V1.0 HCSP-Presales-Campus Network Planning and Design V1.0 Exam Practice Test