Huawei H35-260 Exam Questions Instant Access

Question 1

The device IP addresses of gateway network elements and non-gateway network elements must be set in the same network segment

ATrue

BFalse

Answer : B

Question 2

The router works on the third layer (network layer) of the TCP/IP protocol stack. Which of the following is the main job it completes?

ABinary Data Streaming

BPhysical Media Access

CAddressing and Routing

DEstablish turbulent-to-turbulent connections

Answer : C

Question 3

The M40 board has 2 waves of access, and the power of each wave is -4dBm. So which of the following values is the power of the M40 output port? (M40 insertion loss is 6.5dBm)

A-8.5

B-1

C-10.5

D-7.5

Answer : D

Question 4

When configuring SxCS board for OSN3500. Which of the following is the access capacity of a fully configured subrack?

A35G

B58.75G

C80G

D155G

Answer : D

Question 5

Which of the following descriptions about network protection switching test is wrong?

ABefore testing, you need to set the 1:1 linear multiplex section protection mode to single-ended switching.

BDuring the protection switching of the linear multiplex section, the NE reports the APS_INDI and MS_APS_INDI_EX alarms

CSNCP protection is configured. When the laser of the interface connected to the opposite end is turned off, observe the SDH analyzer of the local end.

DThere are two methods for testing the protection switching of the multiplex section: the single-ended loopback test method and the double-ended hanging meter
test method

Answer : A

Question 6

STM-N signal transmission on the line needs to be scrambled, mainly to facilitate collection and extraction of line timing signals. Will all bytes in the SDH frame structure be

scrambled?

ATrue

BFalse

Answer : B

Question 7

What is the main function of the physical layer?

AProvide a reliable information transfer mechanism

BA retransmission mechanism responsible for error detection and information

CResponsible for the physical and electrical interface between user equipment and network end equipment

DEstablish and clear a network-wide connection between two transport protocol entities

Answer : C

Huawei HCSA-Field-Transmission & PTN V1.0 H35-260 Exam Questions