Huawei H35-560 Exam Questions Instant Access

Question 1

In mobile communication systems, there are usually two ways to define/obtain KPL: eNodeB performance statistics and drive test tools for drive test.

ATrue

BFalse

Answer : A

Question 2

In single-site verification, within the visible target coverage area of the base station, which of the following principles should be met for the RSRP compliance rate of the test road?

AThe probability that F band meets RSRP> -HOdBm and RS-SINR> -3dB is greater than 98%; D band is greater than 90%

BThe probability that F band meets RSRP> -105dBm and RS-SINR> -3dB is greater than 98%; D band is greater than 90%

CThe probability that F band meets RSRP> -lOOdBm and RS-SINR> -3dB is greater than 98%; D band is greater than 90%

DThe probability that F band meets RSRP> -95dBm and RS-SINR >3dB is greater than 98%; D band is greater than 90%

Answer : A

Question 3

The single-site verification test only needs to verify whether the cell status is normal in the idle mode.

ATrue

BFalse

Answer : B

Question 4

For a dual-channel room with single polarization scenario, when antennas are deployed in a long and narrow corridor, in order to reduce antenna correlation, what is the relationship between the antenna spacing and the wavelength of the current frequency band?

AskyLine spacing is greater than4Waveslong

BskyLine spacing is less than4Waveslong

CskyLine spacing is greater than10Waveslong

DskyLine spacing is greater than2Times wavelong

Answer : A

Question 5

The current frequency spectrum of China Mobile's F-band is 1880MHz to 1900MHz.

ATrue

BFalse

Answer : A

Question 6

In an LTE network, an interface can be configured between eNODEB and MME. Which of the following is the interface name?

AS1

BS2

CX1

DX2

Answer : A

Question 7

Which of the following statements about LTE tools is correct? (Multiple Choice)

AProbe can be used for road test and playback

BOMStar can be used for network verification

CM2000 can be used to configure the network and check the message system.

DPRS can be used for simulation and base station selection

Answer : A, B, C

Huawei HCIA-LTE-RNP&RNO V1.0 H35-560 Exam Questions