iSQI CTFL-AuT Exam Questions Instant Access

Question 1

Which of the statements regarding traceability in Automotive SPICES 3.x is true?

AThe linking of requirements, test cases and test togs provides traceability and enables the desired verification of test cases for test case coverage

BA1:N relation exists; for example If a test case is tested with the help of several requirements and is therefore linked to several requirements

CThe linking of a requirement, a derived test case and the associated test implementation provides the base for a complete testability.

DWith complete tractably It Is possible to trace test cases to their requirements and test cases which have been executed to their corresponding results.

Answer : D

Question 2

Which of the following statements regarding the application of standards is true?

AThe application of standards helps to create transparent communication between the project stakeholders.

BThe application of standards which standardize products has the sole purpose to reduce project risks

CThe application of standards primarily alms at reducing costs.

DThe application of standards reduces the efficiency of agile projects

Answer : A

Question 3

Which Automotive Safety Integrity Levels does ISO 26262 describe?

AASIL A, ASIL B, ASIL C, ASIL D

BMlL, SiL, PiL, HiL, ViL

CQM, ASH A, ASIL B, ASIL C, ASIL D

DN (None), P (Partly). L (Largely). F (Fully)

Answer : A

There are four ASILs identified by ISO 26262A, B, C, and D. ASIL A represents the lowest degree and ASIL D represents the highest degree of automotive hazard.

https://www.synopsys.com/automotive/what-is-asil.html#:~:text=There%20are%20four%20ASILs%20identified,highest%20degree%20of%20automotive%20hazard.

Question 4

ISO 26262 recognizes several context factors which influence the selection of testing techniques. Which statement is correct? Please choose the BEST POSSIBLE answer.

AAn testing techniques are always applied to one test basis. The specific techniques, e.g. equivalence partition analysis, however, can always be applied.

BISO 26262 recommends specific testing techniques depending on the ASH level. Furthermore, the current state of technology must be considered

CThe risk assessment provides insights regarding the risks, whose causes will then be tested Intensively (independent of the testing technique).

DFor the selection and the applicability of the test techniques, the test basis is important, but not fie test level.

Answer : B

Question 5

Which of the following options describes a relevant aspect of the design of a test environment for software-ln-the-loop (SIL)?

AA wrapper is used as part of the testing with Software-in-the-Loop (SiL)

BSoftware-m-the-Loop (SL) needs an Interface to the real vehicle or prototype.

CWith Software4rMhe-loop (SI), the tested software is implemented m a real control unit,

DFor Software-in-the-Loop (SIL). usually no specific hardware is used

Answer : D

Question 6

In the release process, which of the following work products. Information and documents are the typical output of the tester?

ATested lest objects

BInsulation recommendation

CNon-detected defects

DChange request

Answer : C

Question 7

Which example describes a typical application of a closed-loop system?

AActivating the hazard warning lights is to be tested To do so. the flashing lights are monitored and the flashing frequency is measured and assessed.

BThe setting of an error memory entry in the motor control unit Is to be tested To do so, the motor temperature is Increased above the critical limit and afterwards, the subsequent error memory entry will be read and assessed.

CThe correct reaction of the windscreen wiper is to be tested To do so. the ram sensor Is activated by water on the screen and the windscreen wiping activities are monitored.

DA cruise control is to be tested by reaching me target speed In a given time and holding this speed despite outside disturbances. Different driving scenarios are simulated for this.

Answer : C

iSQI ISTQB Certified Tester Foundation Level, Automotive Software Tester CTFL-AuT Exam Questions