Juniper JN0-362 JNCIS-SP Exam Questions Instant Access

Question 1

Which two statements are correct about the BGP MED attribute? (Choose two.)

ABGP uses the MED value when peering to two or more connections to the same upstream AS

BBGP routes require the MED attribute be defined

CBGP uses the MED value when peering to two different upstream ASs

DBGP assumes the MED value to be 0, if not already defined

Answer : A, D

Question 2

Click the Exhibit button.

You have configured IPv6 over IPv4 tunneling, as shown in the exhibit. However, hosts connected to network 2001:0:0:1::0/64 cannot communicate with hosts on network 2001:0:0:2::0/64. The router R2 has a similar configuration as the R1 router.

How would you solve this problem?

AConfigure an IGP across the tunnel interfaces

BConfigure an IPv6 address on the tunnel interfaces

CConfigure the next hop of the inet6.0 static route to point to the physical interface between the routers

DConfigure the next hop of the inet6.0 static route to point to the IPv4 address of the remote router

Answer : D

Question 3

Which action would you use to connect two virtual switches that are configured on the same router?

ACreate a VRF routing instance

BCreate a forwarding routing instance

CConnect the virtual switches with a cable

DConfigure an irb interface

Answer : B

Question 4

You have two MX Series devices connected together and configured for Layer 2 operations. The interface that connects the two routers must carry tagged and untagged traffic.

Which approach would meet this objective?

AConfigure the interfaces as access ports with the native VLAN option

BConfigure the interfaces as trunk ports with the native VLAN option

CConfigure the interfaces as access ports with the voice VLAN option

DConfigure the interfaces as trunk ports with the voice VLAN option

Answer : B

Question 5

Which statement about a virtual-router type of routing instance is correct?

AIt is used to separate large networks into smaller administrative entities

BIt is the only routing instance type supported on Junos devices

CIt is used in Layer 3 VPN implementations

DIt is used to create and maintain separate routing and forwarding tables

Answer : D

Question 6

Which statement is true about an OSPF broadcast link?

AAll routers form an adjacency only with the BDR

BAll routers form an adjacency only with the DR

CAll routers form an adjacency with all other routers

DAll routers form an adjacency with both the DR and BDR

Answer : D

Question 7

Click the Exhibit button.

Referring to the exhibit, which two statements are correct? (Choose two.)

AThe router will install the 0.0.0.0/0 route into the routing table when no BGP prefixes are present

BThe router will remove the 0.0.0.0/0 route from the routing table when no BGP prefixes are present

CThe router will remove the 0.0.0.0/0 route from the routing table when any BGP prefixes are present

DThe router will install the 0.0.0.0/0 route into the routing table when any BGP prefixes are present

Answer : B, D

Juniper Service Provider Routing and Switching, Specialist Exam JN0-362 JNCIS-SP Exam Questions