NetApp NS0-163 Exam Practice Test Instant Access

Question 1

Which one of the following statements does not apply to the SnapMirror visibility-interval variable?

AThis variable controls the view of the data on the destination system

BBy setting a value, you specify the amount of time before an automatic snapshot is created on the source volume that is synchronously mirrored

CThe default interval value is 5 minutes

DThe smallest interval value supported is 30 seconds

Answer : C

Question 2

In a fabric-attached MetroCluster, a "site failure" is described as a __________.

Afailure of the Inter-Switch-Links (ISL)

Bfailure of the interconnect cable

Ccomplete failure of the primary controller and disk shelves

Dmalfunction of the Fibre Channel adapter on the cluster node

Answer : C

Question 3

What is the format for snapvault schedule?

AYYYY-MM-DD

Bcrontab format

Ccnt[@day_Hst][@hour_list]

DList of dates in ISO Date format

Answer : C

Question 4

To remove a cluster setup, you must perform the following steps.

1. Type cf disable.

2. Unlicense cluster.

3. Remove partner entries for network interfaces from the /etc/rc file.

4. Halt and make sine the partner-sysid is blank.

5. Power down and remove the cluster interconnect card.

6. Perform steps 1-5 above on the partner node.

ATrue

BFalse

Answer : A

Question 5

When Data ONTAP creates a weekly, nightly, or hourly snapshot, the value of n (as shown by the UNIX Is command) is adjusted for all the weekly, nightly, or hourly snapshots. The higher the value of n. the_________the snapshot.

Anewer

Bolder

Cmore important

Dleast important

Answer : B

Question 6

If an error message indicates that the cluster interconnect adapter itself is faulty, what is your corrective action?

ACheck the cabling of the Channel A disk shelf loop and reseat and tighten any loose cables.

BCheck the cabling of the Channel B disk shelf loop and reseat and tighten any loose cables.

CRe-cable the cluster interconnect adapter or replace the adapter if needed.

DCheck for network activity.

Answer : C

Question 7

In a Fabric Attached Metro Cluster, disk ownership by a node is determined by_____________.

Awhere the FC HBAs for disks connect into the switch, and by where the disks connect to the switch banks.

Bthe types of disks used in the cluster.

Cthe ports on the FC HBA.

Dthe slots in which the FC HBA is installed.

Answer : A

NetApp Certified Data Administrator, ONTAP Professional NS0-163 Exam Practice Test