Nutanix NCSC-Level-1 Exam Practice Test Instant Access

Question 1

A consultant is running Foundation. The cluster creation fails during the process. The host logs confirm that the nodes have been successfully imaged. The consultant decides to create the cluster manually.

Which command should the consultant use?

Acluster -c IP_CVM_A, IP_CVM_B, IP_CVM_n

Bcluster create -s IP_CVM_A, IP_CVM_B, IP_CVM_n

Ccluster -s IP_CVM_A, IP_CVM_B, IP_CVM_n create_manual

Dcluster -s IP_CVM_M, IP_CVM_B, IP_CVM_n create

Answer : B

Question 2

After deploying an AHV cluster connected to Cisco Nexus 9k switches, unexpected network behavior is observed. The consultant needs to rule out physical network mis-cabling without returning to the datacenter.

Which command from the host should the consultant run?

Ashow lldp neighbors

Bshow cdp neighbors

Cshow interfaces

Dlldpctl

Answer : D

Question 3

A consultant finishes creating a new ESXi cluster. The consultant connects to the nodes via laptop and a personal flat switch. The host/CVM network is on VLAN 23. The customer has the native VLAN on the ToR switches set to 23.

The customer wants to use LACP. Before placing the nodes on the customer network, the consultant tags VLAN 23 for each host and CVM. The consultant connects the nodes to the customer network and finds that they are unreachable.

What is causing this issue?

AThe customer has LACP fallback enabled on switch ports.

BThe hosts have not been migrated to a vSphere Distributed Switch.

CUnder the vSwitch0 settings, the consultant did not select Route based on IP hash.

DThe host and CVM are incorrectly configured.

Answer : B

Question 4

A Nutanix cluster has 10TB usable storage. The customer wants to create a 100GB datastore for ISO images to eliminate too much storage being consumed by unnecessary images.

Which setting should be used to accomplish this goal?

AFrom Container Advanced Settings, configure 100GB for advertised capacity.

BFrom Container Advanced Settings, enable erasure coding.

CFrom Container Advanced Settings, turn on compression and deduplication.

DFrom Container Advanced Settings, configure 100GB for reserved capacity.

Answer : A

Question 5

After a recent installation using a flat switch, a consultant notices issues migrating the Nutanix nodes to the customer's network. The customer states that they are using VLANs on the production switch but not on the dedicated switch for IPMI. The customer does not require a manual configuration of the host and CVM.

What network changes need to be made to correct the issues?

AUs untagged VLANs for the CVM and host and trunk mode for IPMI.

BUse Native VLANs for the CVM and host and access mode for IPMI.

CUse tagged VLANs for the CVM and host and access mode for IPMI.

DUse Native VLANs for the CVM and host and trunk mode for IPMI.

Answer : B

Question 6

A consultant is using the Foundation applet to create a cluster. During the process the consultant refreshes the progress bar web page and is concerned when nothing loads.

What should the consultant do to verify that Foundation has completed successfully?

AReturn to the Foundation configuration page and start over.

BUpdate Java on the Foundation VM.

CConnect to any CVM IP address from a web browser.

DRestart the Foundation process.

Answer : C

Question 7

A consultant is planning a new cluster installation and needs to locate the Shared IPMI port for each of the specific nodes that the customer has bought.

Which Support Portal location contains the document that would identify the port?

ASolutions Documentation

BHardware Replacement Documentation

CSoftware Documentation

DKnowledge Base

Answer : B

Nutanix NCSC-Level-1 Nutanix Certified Services Consultant (NCSC): Level 1 Exam Practice Test