VMware 5V0-42.21 Exam Questions Instant Access

Question 1

Which role(s) must be enable under Gateway configuration page to allow a VMware SD-WAN Gateway to build IPsec tunnels to non-VM SD-WAN?

AControl Plane

BControl Plane + Data Plane + Partner Gateway

CControl Plane + Secure VPN Gateway

DControl Plane + Data Plane + Secure VPN Gateway

Answer : B

Question 2

A customer would like to ensure that the traffic towards the Partner Gateway does not exceed a certain bandwidth.

Which feature should be used?

AModify the SD WAN Traffic Class and Weight Mapping

BEnable the SD-WAN Overlay Rate-Limit.

CChange the application priority to low.

DEnable the rate limit under a new custom Business Policy Rule.

Answer : C

Question 3

A network architect from a service provider is designing an architecture using a VMware SD-WAN Partner Gateway handoff.

Which dynamic routing protocol should the engineering choose?

ARIP Version 2

BOSPF

CStatic

DBGP

Answer : A

Question 4

Which characteristic of Software Defined Networks (SDN) is also true for VMware SD-WAN

AVMware SD-WAN requires specialized hardware to run its software

BVMware SD -WAN provides distributed management and control plane

CVMware SU-WAN allows customers to program the forwarding plane

DVMware SD-WAN provides separation of management control plane, and the data plane.

Answer : A

Question 5

Company A has recently acquired Company B and needs to establish network connectivity. Company A has only Cisco for firewalls and VPN. Company B is using VMware SD-WAN.

Which VMware SD-WAN Cloud VPN solution should an administrator configure to establish connectivity?

ABranch to Non VMware SD-WAN Site.

BBranch to SD-WAN Hub

CBranch to Main Office VPN

DBranch to Branch VPN

Answer : A

Question 6

Which VMware SR-WAN component runs the Deep Application Recognition Engine?

AVMware SD WAN Orchestrator

BVMware SD-WAN Controller

CVMware SD-WAN Gateway

DVMware SD-WAN Edge

Answer : B

Question 7

An Enterprise customer just acquired a new company, and the Network Enterprise administrator was tasked to integrate over 20 new branches into their existing SD-WAN network. However, these branches have overlapping IPs with the existing branches subnets.

AConfigure a NAT hand off rule at the VMware SD WAN gateway assigned to these new blanches, translating the new branch subnets into a new nan-overlapping subnet

BConfigure a LAN-side NAT rule at the branch device settings, translating its subnets into a new non-overlapping subnet

CConfigure a NAT firewall rule in each branch, translating its subnets into a new non-overlapping subnet

DConfigure a policy based NAT tor each branch translating its subnets Into a new non-overlapping subnet

Answer : B

VMware SD-WAN Design and Deploy Skills 5V0-42.21 Exam Questions